candybta.blogg.se - Usb to serial mac yosemite

Because it’s a serial port, it’ll say “Not Configured” and that’s normal:įrom the “Advanced” button you can change default settings (usually not needed). This will create a “Network” interface for a modem or serial port. Now click on the ‘+’ sign on the bottom left, and then on the ‘Select the interface and enter a name for the new Service’ click on ‘Interface’ – you should be seeing the ‘USB-Serial Controller D’ there. Your results should be very close to this: On the Mac there are two methods to determine this: Installing should start (takes a couple of minutes to complete)Īfter you restart, check that everything has installed OK.

This is normal, click ‘Continue Installation‘. You’ll get a warning about restarting the computer after the installation is complete.

You may be asked of your username and password – enter them and click ‘OK’ Then ‘Select a Destination’ click on your desired drive and click ‘Continue’ to move forward Once the installer comes up click ‘Continue’ to proceed. Now double click on the PL2303_1.4.0 to start the installation Now double click on the PL2303_1.4.0.dmg to mount the image Time to get the driver! Fire up Safari and browse to and scroll down to Mac.Ĭlick on the ‘PL2303 MacOSX10.6 dmg v.1.4.0.zip’, the Safari Downloads window should come up:

If all is well you should be seeing something like this: Once connected click on the Apple icon and on ‘About This Mac’Ĭlick on ‘USB’ on the left and on the ‘USB-Serial Controller D’

If you want to verify that the adapter and the driver were installed properly click hereĬonnect the device to the Mac.

In addition to that it guarantees I am always getting the most up to date build without having to rebuild the USB drive everytime there is some update.The easiest way to go about installing our Plugable USB to Serial adapter is by starting with the device. I have to install tons and tons of Macs and I want to ensure the customers have correct licensing when doing this which is why I want it to download the full OS each time. Long story short I have seen guides on how to make the full installer that does not get the install from the internet. When I option boot to it, after it attempts to load I get the circle with a slash no symbol. However something changed where this recovery assistant no longer works properly. This would be a small recovery which would have enough to boot OSX and get it from the app store after signing in. In the past I would just use the recovery assistant tool to create a bootable usb from the actual recovery. Hi all, I am trying to create a recovery usb similar to how it used to be in Mountain Lion and Lion.